----- Original Message -----
From: "denton" <denton@oregontrail.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Saturday, April 30, 2005 19:19
Subject: Re: [TenTec] Omni VI power supply
> Thanks Carl...if you have been following my little problem...I use a
> homebrew
Maybe forget the brew! Sorry but just couldn't resist.
power supply feeding a pair of deep cycle batts for the stations
> power supply. I will order an Airpax either locally or via the web.
> Probably would not hurt to get several...one for the Omni, the FT-990 and
a
> couple of lower amperage ones for the vhf/uhf gear.
Local hamhad aproblem years ago and
spent a bundle replacing the Finals.
Problem was finally solved when the rig went to TT. If I remember correctly
they replaced caps in the PA circuit. Never had a problemafter that,
> ----- Original Message -----
> From: "Carl Moreschi" <n4py@earthlink.net>
> To: "tentec" <tentec@contesting.com>
> Sent: Saturday, April 30, 2005 12:05 PM
> Subject: [TenTec] Omni VI power supply
>
>
> >
> > Just add one of the AIRPAX magnetic circuit breakers in line with your
> > supply voltage. These breakers trip in a few milliseconds and are what
> > TenTec used to recommend for this problem. There was quite a discussion
> > of
> > these on this reflector a year or two ago. The part number to get is
> > T11-1-20.0A-01-11C-V. I seem to remember there was a place in Florida
> > where these could be ordered.
> >
> > Carl Moreschi N4PY
> > Franklinton, NC
> >> ----- Original Message -----
> >> From: "denton" <denton@oregontrail.net>
> >> To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
> >> Sent: Saturday, April 30, 2005 2:57 PM
> >> Subject: [TenTec] Omni VI power supply
> >>
> >>
> >> > I have sent my Omni VI back to TT (again) to have the finals
replaced.
> >> > According to Scott I need something that will shut down when the Omni
> > goes
> >> > into ocillation.
> >> > Thus I am asking what power supplies the TT herd is using for Omni
> >> > VI's.
> >> > I can put out a want for the Omni's matching supply, but would also
> >> > like
> >> to
> >> > take a look at other things...thanks.
> >> >
> >> >
> >> > _______________________________________________
> >> > TenTec mailing list
> >> > TenTec@contesting.com
> >> > http://lists.contesting.com/mailman/listinfo/tentec
> >>
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> >
> >
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|