TenTec
[Top] [All Lists]

Re: [TenTec] DC power questions re Ten-Tec 516

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] DC power questions re Ten-Tec 516
From: "Stuart Rohre" <rohre@arlut.utexas.edu>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 7 Mar 2005 21:50:22 -0600
List-post: <mailto:tentec@contesting.com>
The radio is spec'd at 13.8 Volts, ie. a fully charged battery on a car.

However, since the fans used are 12 volt fans, the radio will operate on 12
volts DC.

In the Scout, the stability suffered at less than 11 volts, and I am sure
with more digital circuits the Argo V is similar.   You have to have a 3
volt differential for voltage regulators commonly used to regulate reliably.

I do not have the current drains except as shown on Ten Tec site for receive
only 950 ma, and transmit at 20 watts being 7 amps max.  You could safely
figure a quarter of that for 5 watts at 13.8 Volts.

73,
Stuart
K5KVH



_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>