Tommy,
I consider myself a serious DX'er and would not think of operating any of my
radios without my control program. I can find the caller in a split DX
pileup much faster with the aid of my control program. I also can band hop
around to check out several different frequencies much quicker, with all my
settings saved at each frequency. When a DX station is listening on his own
frequency and suddenly announces he is listening up 5, I can be there in a
second and beat everyone else calling there.
Carl Moreschi N4PY
Franklinton, NC
----- Original Message -----
From: "Tommy" <>
To: <tentec@contesting.com>
Sent: Monday, January 24, 2005 4:44 PM
Subject: Re: [TenTec] Orion Warranty
> The bottom line is a control program should be an 'addition to' a
> radio, but not 'in place of' parts of a radio. I think a lot of us
> much rather utilize the radio rather than play with a computer. I
> doubt that a serious DX'er or contester uses control programs for
> their operations, therefore, again, the radio should work
> stand-alone.
>
> Tom - W4BQF
>
> ----- Original Message -----
> From: "Toby Pennington" <toby423@earthlink.net>
> To: <tentec@contesting.com>
> Sent: Monday, January 24, 2005 2:55 PM
> Subject: Re: [TenTec] Orion Warranty
>
>
> > Interesting about the RIT encoder.
> > Someone suggested using the N4py control program and leaving the
> > knobs alone
> > on the front panel, that way they will last longer and the front
> > panel will
> > not show wear. However, I know that is not the answer to your
> > problem, and
> > the encoders should be holding up better. Toby W4CAK
> >
> >
> > ----- Original Message -----
> > From: "melinda lyon" <melindalyon@juno.com>
> > To: <tentec@contesting.com>
> > Sent: Monday, January 24, 2005 7:55 AM
> > Subject: [TenTec] Orion Warranty
> >
> >
> >>
> >>
> >> RIT/XIT Encoder
> >>
> >> Well I am now on my third RIT/XIT encoder. It is discouraging
> >> that TEN
> >> TEC does not think this is a problem. I have talked to them (Paul
> >> Clinton
> >> at Ten Tec) about it, and they will replace it no problem, but
> >> fixing the
> >> design so it is not a problem again and again, no they are not at
> >> that
> >> point yet. And yes pulling out on the knob works for a awhile,
> >> but after
> >> a period of time the encoders go intermittent again.
> >>
> >> Robye Lahlum
> >>
> >> W1MK
> >> _______________________________________________
> >> TenTec mailing list
> >> TenTec@contesting.com
> >> http://lists.contesting.com/mailman/listinfo/tentec
> >>
> >
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|