Hi,
I will try to pinpoint the situation and also will post again on the list,
your ideas will be apreciatted (Maybe a book to be read)
1.- It takes almost a minute to load the software at radio startup, is
this normal???
2.- The Orion on the other hand has a lot of background noise on most any
band and I cannot seem to get rid of the noise (I saw it posted today)
3.- I spend my time mostly in 80 & 160 mts and in CW I found those
parameters reasonable for me BW: 1720 PBT:150 but once a low signal
station
appears (most of the times) I start to move the PBT/BW & CUT randomly
without understanding what I am doing just relaying on my ears.
I would like to have a criteria to use those powerful weapons :)
Of course instead all this situation I had been able to copy stations that
with my SuperCharged Mark V were at noise level :)
4.- In SSB the situation is worst and it's very difficult for me to hear
clear audio because I got stuck with the filters use and I am most of the
time unable to have a reliable audio.
5.- In terms of graphics I see a vertical line while I move the filter fro
on side to another, I had read that to align the filters I had to press
for 2 seconds either the CUT or PBT and this happens, but I have not idea
were
I am at that time, so I spend some time from station to station moving the
cut/pbt & bw randomly until a decent signal is picked up. Maybe the rig
it's to much for me :(
6.- At ANT 1 port I have a low band ant & ANT 2 yagi, while using ANT1 the
watmmeter installed between ANT2 port and coax switch moves a litlle ?????
STILL I AM VERY PLEASED WITH THE RIG THE PROBLEM IS THE HANDLER Hi-Hi!!!!
73's de Javier
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|