TenTec
[Top] [All Lists]

Re: [TenTec] re Ten Tec amps and ALC

To: tentec@contesting.com
Subject: Re: [TenTec] re Ten Tec amps and ALC
From: don daso <k4za@juno.com>
Reply-to: tentec@contesting.com
Date: Thu, 19 Aug 2004 20:20:15 -0400
List-post: <mailto:tentec@contesting.com>
The ACOM is 0 to -11volts, if my memory of conversations w/the gang
@K4JA's station is correct

Automatic Drive Level, known as ALC for short, was originally designed to
limit grid current, preventing overdrive by applying a negative DC
voltage "back" to the exciter/transmitter, especially useful in tetrode
amp situations.

Today, our amps require a drive level between 50-80 W for legal limit. 
You can use ALC or not.

Circuits can be internal or external; they can be set by the op, or
automatic.  

If external ALC isn't used, the output of the exciter/transmitter should
be reduced using the power output control to avoid over-driving the grids
of the amp.  Some ALC circuits (like the Emtron amp) produce a negative
1-10Volts, proportional to the grid current, when overdriving the
tube(s).  It's not as easy to over-drive, say, a pair of 3-500Zs w/a
typical 100W rig....

And today, not all transceivers (which have generally replaced
exciters/transmitters) have a direct ALC jack or output jack.  Recent
KENWOOD rigs, for instance, have the ALC on a DIN-plug (the REMOTE jack),
while the FT-1000 has one.

N1EU once had a good write up on ALC circuits on his web-site (along
w/lots of other useful information on contesting/DXing/modern rigs).  I'm
sure a quick Google search would turn up that link.

I gave up using ALC when I began using triodes in grounded grid.  Never
had a rig capable of over-drive.

GL & vy 73 de Don K4ZA
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>