Depending on the amplifier, it may be possible to have your keyer output
key the amp, and then the amplifer's "TX ready" output drive the
transmitter keying input. Of course this method doesn't allow for use of
the built in keyer.
Also, there is no provision for keying a QSK linear (at any speed).
73
Rick
Are you sure about that Rick? I'm not saying you're wrong but it's hard to
imagine. Or are you refering to a loop circuit which only Ten Tec use, so
far as I know.
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|