Bob,
Well, to the letter, I must admit that I am not personally sure.
However here's my source of info on that data point:
RadCom, August 2004 edition, page 18, written by Peter Hart, G3SXJ:
"There is a transverter drive capability giving about -20dBm on transmit and
switching for linear amplifiers accommodates a wide range of switching
voltages and currents although no particular features for QSK linears."
Normally Peter is pretty accurate with his reports on rigs.
73
Rick
-----Original Message-----
From: tentec-bounces@contesting.com
[mailto:tentec-bounces@contesting.com]On Behalf Of Bob Henderson
Sent: Tuesday, August 10, 2004 7:32 AM
To: tentec@contesting.com
Subject: Re: [TenTec] G3SJX IC-7800 review
----- Original Message -----
From: "NJ0IP" <Rick@dj0ip.de>
To: <tentec@contesting.com>
Sent: Tuesday, August 10, 2004 6:49 PM
Subject: RE: [TenTec] G3SJX IC-7800 review
> Also, there is no provision for keying a QSK linear (at any speed).
>
> 73
> Rick
Are you sure about that Rick? I'm not saying you're wrong but it's hard to
imagine. Or are you refering to a loop circuit which only Ten Tec use, so
far as I know.
Bob, 5B4AGN
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|