Gary
Unplug the key from the rig then see if it still keys up.If it does I'd
start at the mode switch and work back.
Joe K4XZ
>
> From: "Gary L. Ingersoll" <wb8icu@juno.com>
> Date: 2004/07/29 Thu PM 06:59:01 EDT
> To: <tentec@contesting.com>
> Subject: [TenTec] omni d problem
>
> I have an omni d with a weird problem. The rig keys up every time the cw
> position is brought up with the mode switch. No ground showing up on the t/r
> line to explain this. Also, when turned to the lock position, which SHOULD
> key it up, nothing happens. I am reading about 13 volts on the T line all
> th time, tx or rx. I'm having a hard time following the schematic, since so
> many things tie together. Also, all the voltage readings are wrong on the
> control board. Since Ten Tec doesnt give me much idea of the inputs
> expected, I can't tell where to start.
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
JOE PATRICK
SENIOR PLUMBING/MECHANICAL
INSPECTOR CITY OF BOYNTON BEACH
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|