From: "Ten-Tec Inc. Amateur Radio Sales" <sales@tentec.com>
Reply-To: tentec@contesting.com
To: tentec@contesting.com
Subject: Re: [TenTec] SO2R with only one TenTec ORION?
Date: Thu, 22 Jul 2004 09:05:36 -0400
It's a limitation of hardware - there would be some serious isolation
issues
involved with allowing one receiver to be open while transmitting at 100
watts on another band with the same piece of equipment. We did some
investigating of this early on in the Orion development (because as an
SO2R op myself, I really would have liked this). It was soon obvious
that the engineering challenge plus the hardware involved was going to
be too much effort and cost added to the rig to do it. We did leave on all
the other "SO2R style" acoutrements like the second amp keying line, etc.,
but the muting of the opposite receiver while transmitting is not the usual
modus operandi for the SO2R operator. The point of SO2R is to be doing
something productive while calling CQ rather than listening to your own
CQ's all weekend.
Solution: two Orion's.
Scott Robbins
W4PA
At 04:42 AM 7/22/04 +0000, you wrote:
Now that's an interesting question.
The Orion has two receivers and produces two sets of band data for
independent selection of antennas. However, for SO2R you would need to be
able to listen on one band whilst transmitting on another.
Currently that's not possible with Orion though if one of its receivers is
completely independent of the transmit chain then in theory it could be.
I may be wrong but something tells me it's more than just firmware
limitations that prevent this.
Bob, 5B4AGN
----- Original Message -----
From: "OE3ZK Gerhard" <oe3zk@aon.at>
To: <tentec@contesting.com>
Sent: Tuesday, July 20, 2004 4:03 PM
Subject: [TenTec] SO2R with only one TenTec ORION?
Has somebody experience? Is this possible?
73
Gerhard, OE3ZK
-----------------------------------------------------------------
Ten-Tec, Inc., 1185 Dolly Parton Pkwy, Sevierville, TN 37862 USA
Contact Mon-Fri Eastern: Office/Tech (865) 453-7172 9 am-5 pm.
Repair (865) 428-0364 8-4. Sales (800) 833-7373 9 am-5:30 pm.
Fax (865) 428-4483 24 hrs. Visit us at <http://www.tentec.com>
Email: New product sales/product info sales@tentec.com
Service department service@tentec.com
While we make every effort to answer email in an expedient manner,
the telephone is a much more efficient tool for getting a quicker and
more complete answer to your inquiries. Thanks!
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec