I just received my SteppIR antenna this past week. I have not assembled
it yet but I did order it with the Orion interface. The cable that came
with it is the K2 Cable (nine pin plugs on both ends). I'm not sure if this
helps, but it is the best that I can do.
I would call SteppIR tomorrow morning and ask them. They definitely
should be able to tell you what to do.
73
Bernard, WA4OEJ
----- Original Message -----
From: "Jeff Griffin" <kb2m@comcast.net>
To: <SteppIR@yahoogroups.com>; <tentec@contesting.com>
Sent: Sunday, May 23, 2004 12:42 PM
Subject: [TenTec] SteppIR Ten Tec Orion interface
I just got back from Dayton where I exchanged my Icom interface board for a
Orion to SteppIR interface board, that resides inside the SteppIR control
box. Does anyone have this combination? What I need is the pinout for an
Orion to SteppIR cable. I have the original SteppIR to Icom cable, so all I
need to do is get the pinout for the Orion end. Also what input on the Orion
to use, I'm assuming the band data on one or two connector?
73 Jeff kb2m
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|