Jeff.
My SteppIR control box turned out to be the beta-testing box for this
interface. SteppIR had my box (with weekly apologetic messages) for about a
month until they figured out the interface change. Problem was the 57.5 kb
interface speed which they hadn't considered when they designed the control
board.
Anyway it has worked just fine since I got it back using the same cable as
before. It now works for both my Yaesu MarkV and the Orion. I did order a
Y-cable from SteppIR so I could use simultaneously my computer and the
SteppIR control. So far it hasn't worked for me...maybe I don't understand
something :(
I don't know anything about the ICOM interface. Have you tried it with your
Orion?
Torrey N9AUJ
----- Original Message -----
From: "Jeff Griffin" <kb2m@comcast.net>
To: <SteppIR@yahoogroups.com>; <tentec@contesting.com>
Sent: Sunday, May 23, 2004 12:42 PM
Subject: [TenTec] SteppIR Ten Tec Orion interface
I just got back from Dayton where I exchanged my Icom interface board for a
Orion to SteppIR interface board, that resides inside the SteppIR control
box. Does anyone have this combination? What I need is the pinout for an
Orion to SteppIR cable. I have the original SteppIR to Icom cable, so all I
need to do is get the pinout for the Orion end. Also what input on the Orion
to use, I'm assuming the band data on one or two connector?
73 Jeff kb2m
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|