Pushing the hi/lo cut knobs in for 2 seconds only returns the PBT back to
the default value.... Are you sure that's not happening there??
Mine operates as described in the manual.....
de Tom NJ1K
----- Original Message -----
From: "w4tje" <w4tje@mindspring.com>
To: <tentec@contesting.com>
Sent: Friday, May 21, 2004 7:20 AM
Subject: Re: [TenTec] Orion Notes, High/Low Cut
> They don't change, other than the normal bandwidth change made by
> tightening up the filter. But when I then push in and hold the high/low
> knob, the receiver sound is dramatic.
> Here's another example: bw is set to 2900. i then tighten high cut to
2200.
> the receiver action of reducing the bw to 2200 is noticeable. But then by
> pushing in and holding high cut knob for a second or so, the receiver
> really gets quiet on the high end. And nothing else has changed on the
> scree with regard to rit, or pbt.
> Jack W4TJE
>
> At 06:46 AM 5/21/2004 -0400, you wrote:
> >In a message dated 5/20/2004 22:44:06 PM Eastern Daylight Time,
> >w4tje@mindspring.com writes:
> >when qrm comes on above my freq. I tighten up
> >the high cut filter, and then push the knob, holding it down for several
> >seconds. The action created by pushing in and holding the knob is much
more
> >dramatic and effective than by only turning to tighten the filter.
> >I can;t duplicate this. What does the BW, PBT and RIT readout say before
and
> >after you push the button?
> >
> >
> >Radio k4ia
> >"Buck"
> >Fredericksburg, Virginia USA
> >_______________________________________________
> >TenTec mailing list
> >TenTec@contesting.com
> >http://lists.contesting.com/mailman/listinfo/tentec
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|