Mark, the 705 will work with voltage supplied through the mike plug on the
front of your Ten-Tec radio. It's only needed if you use a 705 on a non - Ten
Tec radio.
So first take the battery out. Make sure the black "lock" button stands up
above the top of the mike case, and you can feel the switch operate when you
push and release the black button. Ditto the grey PTT button. Then look under
your mike's "chin" for the PTT-VOX switch. Exercise it a few times to insure
good contact, then leave it set in PTT. Try it again. It should work.
73 Pete Allen AC5E
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|