There is a manual and schematic for the 705 mic available online as .pdf
download at www.qsl.net/tentec/manuals<http://www.qsl.net/tentec/manuals> .
Hope you have already got it working from all the other suggestions.
73. Ed/w4wvw
----- Original Message -----
From: Mark Toussaint<mailto:n1mt@yahoo.com>
To: tentec@contesting.com<mailto:tentec@contesting.com>
Sent: Saturday, March 13, 2004 7:02 AM
Subject: [TenTec] Problem with 705 mic
I recently purchased a used 705 mic and it has a
problem. Before I send it back, I wanted to see if
there are some suggestions you folks might have on its
repair.
1. The mic came without a 9 volt battery, so I put one
in and noticed the red transmit LED was on.
2. Hitting both the PTT and lock switches on the base
had no effect on turning it off.
3. I opened the 4 pin connector and all looked good
there (nothing shorted across PTT and GND pins)
4. I put the mic on my omni 6 and when plugged in, it
immediately kicks the rig into transmit and it does
work, provide audio to the rig.
When I open the base up later today, any suggestions
on what to look for (don't have a schematic but can't
imagine its too complex) ?
Thanks in advance, Mark N1MT
__________________________________
Do you Yahoo!?
Yahoo! Mail - More reliable, more storage, less spam
http://mail.yahoo.com<http://mail.yahoo.com/>
_______________________________________________
TenTec mailing list
TenTec@contesting.com<mailto:TenTec@contesting.com>
http://lists.contesting.com/mailman/listinfo/tentec<http://lists.contesting.com/mailman/listinfo/tentec>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|