W4BQF wrote:
"Does everyone notice that with v1369, the sweep function stops as you tune
the VFO know? Mine does and if your trying to get to a signal on the sweep
screen, you have to stop turning the VFO and wait for the sweep to refresh
again. Not too bad, but annoying."
Tom, I also have observed this condition, however, I have not had a system
lock-up with v1.369.
Larry W6UB
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|