I don't understand how that solves the problem. The problem is the
difference in level between the radio audio and the sidetone. Adding a
resistor will reduce both equally. Am I missing something?
73,
Mark W1EOF
> -----Original Message-----
> From: tentec-bounces@contesting.com
> [mailto:tentec-bounces@contesting.com]On Behalf Of Carl Moreschi
> Sent: Thursday, February 05, 2004 8:31 AM
> To: tentec@contesting.com
> Subject: Re: [TenTec] Omni V - sidetone/headphone problem?
>
>
> Add a 100 ohm resistor in series with the headphones. This will even out
> the headphone volume to the speaker volume. You can add this
> resistor right
> into the headphone plug from your headphones.
>
> Carl Moreschi N4PY
> Franklinton, NC
> ----- Original Message -----
> From: "james murray" <jmcm@capital.net>
> To: <tentec@contesting.com>
> Sent: Thursday, February 05, 2004 5:43 AM
> Subject: [TenTec] Omni V - sidetone/headphone problem?
>
>
> Picked up a nice used Omni V and very impressed with it so far.
> One problem
> I came up with is that when I put the headphones on the first time the
> sidetone rattled my eardrums a bit. In order to use headphones I had to
> turn the sidetone all the way down. When I pull the phones out
> sidetone is
> barely audible. Headphones are
> Yaesu YH-55, 8ohm. Manual says 4-16 ohms. Any ideas.
> tnx,
> Jim/k2hn
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|