the problem... is only there with this one module, in either scout radios..
so, the bug has to be with the module...
Mike Bryce, WB8VGE
SunLight Energy Systems
http://www.seslogic.com
http://www.theheathkitshop.com
> From: "Larry" <w5wlb@gbronline.com>
> Reply-To: tentec@contesting.com
> Date: Sun, 23 Nov 2003 07:30:05 -0600
> To: <tentec@contesting.com>
> Subject: Re: [TenTec] scout display problem with 40 meter module
>
> Mike
>
> The only time I have had that problem was when the module was not firmly
> seated in place.
> W5wbl
> ----- Original Message -----
> From: "MIKE BRYCE" <prosolar@sssnet.com>
> To: <TenTec@contesting.com>
> Sent: Saturday, November 22, 2003 4:45 PM
> Subject: [TenTec] scout display problem with 40 meter module
>
>
>> here's an unusual problem.
>>
>> I have two scout transceivers. two forty modules.
>>
>> one of the modules causes the display to become unstable when in transmit
> on
>> ssb. cw seems to be fine. it's the module, because I can move it from one
>> radio to the other and the problem follows the module.
>>
>> so, after I have taken the module apart and looked for the obvious broken
>> solder joints, has anyone ever had this problem with a band module?
>>
>> Mike Bryce, WB8VGE
>> SunLight Energy Systems
>>
>> http://www.seslogic.com
>> http://www.theheathkitshop.com
>>
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|