From: "J. W. (Dub) Thornton" <dub@oklahoma.net>
Reply-To: tentec@contesting.com
To: wb2vuf@qsl.net, tentec@contesting.com
Subject: Re: [TenTec] Using Scout w/external keyer
Date: Wed, 27 Aug 2003 10:56:57 -0500
At 10:05 PM 8/26/2003 -0400, you wrote:
Actually, it has been my experience that the problem is worse with
external keying, at least when I use a straight key, I experienced very
severe warmup drift. Putting in the mod described in QST a couple of
years ago will fix the problem. I can send you the mod if you don't have
it. It was discussed on this reflector.
Bob: I have been contemplating a Scout for my mobile rig for some
time now, but have not yet made the move. One of the delaying
factors has been the notorious freq hop/skip/jump that so many of
the scouts show. It sounds just like the PTO hop of all the older
Ten Tec rigs that are in need of a bit of TLC on the PTO. Even so, I
am a big fan of Ten Tec, with 7 of their old rigs on hand.
I would like to see the mod, if it is not too much trouble for you to send
it.
"73" Dub
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec