Most likely a diode in the SWR / ALC ckt that has taken a dump.
It's a pain to get to as I recall. It's buried on the back side near the
output SO-239. I sent mine back to TT to fix.
73
Bob, K4TAX
----- Original Message -----
From: "popella" <rmpjr@forcomm.net>
To: <tentec@contesting.com>
Sent: Wednesday, August 13, 2003 3:03 PM
Subject: Re: [TenTec] Omni 6+ power
> Thats 55w max on tune.
> ----- Original Message -----
> From: "Bill NY9H" <ny9h@arrl.net>
> To: <tentec@contesting.com>
> Sent: Wednesday, August 13, 2003 9:03 AM
> Subject: Re: [TenTec] Omni 6+ power
>
>
> > would that be tune or cw mode ???
> > bill
> >
> > At 12:57 PM 8/13/03, you wrote:
> >
> > >Anyone have advice on increasing the power output on an Omni 6+??
> > >My rig showing output of only 55 watts on any band. Seems the pot to
> > >increase power is located on the 9 Mhz board under the rig. Any
simple
> way
> > >of increasing the power (getting to the pot) without needing to
> disconnect
> > >the whole shack while removing the bottom cover??
> > >
> > >73 Rob KA3S
> > >
> > >_______________________________________________
> > >TenTec mailing list
> > >TenTec@contesting.com
> > >http://lists.contesting.com/mailman/listinfo/tentec
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
|