Actually, all was well with output. However, I sent the rig to TenTec a
while back, and when I received it back, I noticed it was sitting near this
output level (55-60w) after their re-alignment.
I never had the gumption to do anything about it until now. Figure why
have my Omni at the output level of a Scout, when I could have full
output.
----- Original Message -----
From: "Stuart Rohre" <rohre@arlut.utexas.edu>
To: <tentec@contesting.com>
Sent: Wednesday, August 13, 2003 10:35 AM
Subject: Re: [TenTec] Omni 6+ power
> Check your power supply, and wiring to rig and connections like a burned
> fuse holder, corroded fuse, etc. You have more than a pot adjustment
> problem. It should do 100 watts output.
> 73,
> Stuart
> K5KVH
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
|