Thanks Duffy for the words concerning the audio mixer. --- You are
correct, I adjusted in Playback mode - not in Recording. Now, I have to
locate that cable again and reconnect it. I hope this works. I will let
everyone know by tomorrow this time. Its off to slumberville now - 6am
comes early!
Thanks --- Jim --- N8LUV
On Wed, 30 Jul 2003 21:00:36 -0400 (Eastern Standard Time) "J. D."
<duffyb01@fuse.net> writes:
> Jim,
>
> When you adjusted the audio controls of the soundcard, did you
> adjust the
> levels when it is in recording mode or playback mode? Common
> mistake that
> people miss. Go to the audio mixer in windows, then to options,
> then to
> properties, then check "recording" then adjust. Hope that does
> it.
>
> Duffy
> www.wb8nut.com
>
> -------Original Message-------
>
> From: tentec@contesting.com
To: <tentec@contesting.com>
> Date: Wednesday, July 30, 2003 8:52:33 PM
> To: tentec@contesting.com
> Subject: Re: Works with Orion....Re: [TenTec] MixW and use with
> Orion
> andArgonautV
>
> Jim - N8LUV - here in Michigan, (Argonaut-V)
>
> Yes, N4PY's suggestion does work. MixW is now handeling the freq. as
> well
> as mode in fine business on my Argonaut-V. --- However, I still have
> not
> got the Aux Jack - #1 with the optional cable to work with the
> Dell
> computer's soundcard. The computer is hearing nothing! --- Sure
> would be
> nice to get all of this to fly! --- Wow, all modes, a log, and rig
> control all in one program - great if I can get it all to fly. I
> am
> closer now then I was a few days ago.
>
> Jim --- N8LUV
>
>
> On Wed, 30 Jul 2003 20:13:35 -0400 (Eastern Standard Time) "J. D."
> <duffyb01@fuse.net> writes:
> > When I got home I set the baud rate in MixW to 1200 as N4PY
> suggested
> > and it
> > worked! I have the RTS and DTR to "always on" you may try that and
>
> > see if
> > the changes go both ways.
>
> >
>
> > Regards,
>
> >
>
> > Duffy
>
> > www.wb8nut.com
>
> >
>
> > -------Original Message-------
>
> >
>
> > From: tentec@contesting.com
>
To: <tentec@contesting.com>
> > Date: Wednesday, July 30, 2003 7:49:02 PM
>
> > To: tentec@contesting.com
>
> > Subject: Works with Orion....Re: [TenTec] MixW and use with Orion
>
> > and
> > ArgonautV
>
> >
>
> > Hi Duffy,
>
> >
>
> > Well, I just set up Mix to control my Orion as you suggested (used
>
> > 57k6
>
> > bps, RTS always on, DTR PTT+CW but will also try PTT via CAT) and
> I
> > can
>
> > command the Orion! It appears to be one way, i.e. MixW32 does not
>
> > catch
>
> > when I change the frequency with the main dial or aux dial so
> > perhaps Mix
>
> > is not polling the Orion. But the wheel mouse does work so I will
>
> > just
>
> > leave the dials alone.
>
> >
>
> > Now to test being able to transmitt! After rewriting my macros to
>
> > remove
>
> > the FT-1000MP Mk V commands and see if Orion commands work!!!
>
> >
>
> > Thanks for the info.
>
> >
>
> > 73, Tom N4ZPT
>
> >
>
> >
>
> > On Wed, 30 Jul 2003 10:41:20 -0400, <duffyb01@fuse.net> wrote:
>
> >
>
> > > I sent Nick an email about enhancing MixW to control the Orion
> and
> > the
>
> > > Argonaut V. I also sent him files related to the PC control of
> the
> > Orion
>
> > > and the Argo. This is what Nick said:
>
> > >
>
> > >>>> Hello Duffy,
>
> > > Please try "Jupiter (enhanced PC control) with
>
> > > Argonaut - V and ORION
>
> > > The documentation says that Jupiter, ORION and Argonaut have
> same
> >
>
> > > commands
>
> > > for frequency and mode control.
>
> > > Please let me know the result.<<<
>
> > >
>
> > > O.K., so I tried it as suggested with the Argonaut V and simply
>
> > cannot
>
> > > get it to work. I have used the same settings that I use with my
>
> > Jupiter
>
> > > and MixW is simply unable to control the Argo. Can anyone else
> give
> > this
>
> > > a shot? Does anyone else have any suggestions as to why it is
> not
> >
>
> > > working? The N4PY software works perfect with the Argo, but
> cannot
> > get
>
> > > the same result with MixW.
>
> > >
>
> > > Anyone up to the challenge?
>
> > >
>
> > > Regards,
>
> > >
>
> > > Duffy
>
> > > www.wb8nut.com
>
> > >
>
> > >
>
> > >
>
> > > _______________________________________________
>
> > > TenTec mailing list
>
> > > TenTec@contesting.com
>
> > > http://lists.contesting.com/mailman/listinfo/tentec
>
> > >
>
> > >
>
> >
>
> >
>
> >
>
> > --
>
> > Tom Azlin, N4ZPT
>
> >
>
> > _______________________________________________
>
> > TenTec mailing list
>
> > TenTec@contesting.com
>
> > http://lists.contesting.com/mailman/listinfo/tentec
>
> > .
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> >
> >
>
> ________________________________________________________________
> The best thing to hit the internet in years - Juno SpeedBand!
> Surf the web up to FIVE TIMES FASTER!
> Only $14.95/ month - visit www.juno.com to sign up today!
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> .
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
________________________________________________________________
The best thing to hit the internet in years - Juno SpeedBand!
Surf the web up to FIVE TIMES FASTER!
Only $14.95/ month - visit www.juno.com to sign up today!
|