Mike,
I think you're right. I wonder if anything can be done with the 6N2? With
this condition, it's not going to replace the 2m FM rig in the shack as I
had hoped.
Mark
----- Original Message -----
From: <k0myw@att.net>
To: <tentec@contesting.com>
Sent: Tuesday, July 01, 2003 8:42 PM
Subject: Re: [TenTec] 6N2 questions
> Mark,
>
> My 6N2 appears to overload and clip audio on strong simplex signals. I
don't
> think you're experiencing a problem with the repeater...
>
> 73,
> Mike, k0myw
>
>
>
>
> > Jerry,
> >
> > Thanks for the reply. If this is the case, is this a problem with my
> > receiver or with the repeater? And, assuming I can't do anything about
the
> > repeater, what can I do about it?
> >
> > 73,
> > Mark
> >
> > ----- Original Message -----
> > From: "Dr. Gerald N. Johnson, electrical engineer" <geraldj@isunet.net>
> > To: <tentec@contesting.com>
> > Sent: Tuesday, July 01, 2003 11:48 AM
> > Subject: Re: [TenTec] 6N2 questions
> >
> >
> > > Audio cutting out on FM is often a sign of the receiver squelch being
> > > set too tight when the repeater has a little bit hot audio. Like the
> > > local 147.240 repeater here.
> > >
> > > 73, Jerry, K0CQ
> > >
> > > --
> > > Entire content copyright Dr. Gerald N. Johnson, electrical engineer.
> > > Reproduction by permission only.
> > > _______________________________________________
> > > TenTec mailing list
> > > TenTec@contesting.com
> > > http://lists.contesting.com/mailman/listinfo/tentec
> > >
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
|