I've used the Bencher/MFJ and like the feel but I'm so fat-fisted that when
I was moving things around on the desk that I would inevitably hit the
paddles which are held in place by springs and "BOING!" they would fly out
of position.
I finally settled on my favorite Iambic Paddle - The Brown Brother's with
the red paddles. There is room at the back of the base where I mounted an
MFJ keyer on its side using double sided foam tape. I then replaced the
keyer volume control with a replacement shaft encoder from Ten-Tec and a
spinner knob off of an old VTR shuttle controller. I can tune my Omni-V.9+
around using my thumb and send cw without moving my right hand more than 3
inches while I write with my left. Nice feel and when I bump into it all I
get is a dit or dah but no "boing".
Tom K2TA
tom@k2ta.com
----- Original Message -----
From: "jdanter" <jdanter@mail.i-america.net>
To: "TenTec List" <tentec@contesting.com>
Sent: Monday, April 14, 2003 4:10 PM
Subject: [TenTec] Q: Iambic Keys
> Which Iambic Keys do you use?
> I presently use a Vibroplex Brass Racer,
> and would like your suggestions.
> Price range around $100.
> TNX,
> jamie/KF4VOP
>
> ---
> [Pre-scanned for viruses by Internet America.]
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
|