tIM,
iF ITS LIKE MY cORSAIR, WHEN YOU INSTALL THE 1.8MHZ FILTER YOU HAVE TO
CUT A JUMPER ON THE BOARD. LOOK FOR A SHORT LOOP OF WIRE NEXT TO THE
FILTER.
bOB WB2VUF
tlogan7@cox.net wrote:
>
> Hi folks -
> When I kick in the 1.8 filter (from the 6.3 board - not the 9MHz board) on
> my recently acquired Omni VI+, it doesn't seems as though it's having any
> effect. Yes, the filter is there and the rig was checked by Ten Tec in Dec
> (per receipt). Otherwise it is a thing of operational beauty. Can I be
> imagining this or is there possibly a jumper etc etc that might not be
> placed correctly causing the filter not to activate? The front panel light
> does work and I still do get the signal when the filters on. Any ideas?
> 73/Tim NZ7C
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
|