TenTec
[Top] [All Lists]

[TenTec] [OT] Metal Roof as Ground Plane

To: <tentec@contesting.com>
Subject: [TenTec] [OT] Metal Roof as Ground Plane
From: RMcGraw@Blomand.Net (Robert & Linda McGraw K4TAX)
Date: Tue, 21 Jan 2003 12:42:01 -0600
I agree.  Having used a Butternut when living in FL, I mounted my on a
bollard at our dock which was on a salt water, tidal canal.  Worked great.
I'd say as Carl suggests, put it at the top in the center.  If you need to
guy the vertical, use Dacron.

73
Bob, K4TAX

----- Original Message -----
From: "Carl Moreschi" <n4py@earthlink.net>
To: <tentec@contesting.com>
Sent: Tuesday, January 21, 2003 11:55 AM
Subject: Re: [TenTec] [OT] Metal Roof as Ground Plane


> Mark,
>
> I think a vertical on a metal roof barn would work beautifully.  You would
> not need any radials since the roof is the ground plane.  I would mount
the
> antenna as near the center of the roof as possible and connect the shield
of
> the coax to the roof as near the antenna feed point as possible.
> There should be no issue with RF inside the barn.
>
> Carl Moreschi N4PY
> Franklinton, NC
> ----- Original Message -----
> From: "Mark Erbaugh" <mark@microenh.com>
> To: <tentec@contesting.com>
> Sent: Tuesday, January 21, 2003 5:23 PM
> Subject: [TenTec] [OT] Metal Roof as Ground Plane
>
>
> > Since most of my HF equipment is TenTec, there is some tangential
> > relationship to this list <g>.
> >
> > I have a 24 by 48 foot metal barn with a metal roof. The peak of the
roof
> is
> > about 20 feet high. Is there a wait to exploit this structure as a
ground
> > plane for an HF vertical antenna? What kind of performance improvement
(if
> > any) could I expect over the same antenna mounted on the ground. Would I
> > still need radials?
> >
> > Currently, I have a Butternut HF6V and a Cushcraft AV5 antenna
available.
> I
> > also have a Gap Challenger, but I understand that it doesn't use a
ground
> > plane (elevated feed point). Would it be worth trying any of these
> antennas
> > on the barn roof?
> >
> > The ham shack is not in the barn and the barn would not normally be
> occupied
> > (it's just storage) when I'm on the air, but would RF exposure inside
the
> > barn be an issue.
> >
> > 73,
> > Mark
> >
> > P.S. There's 2 inches of snow on the ground and temps in the 20s and I
> have
> > good antennas up now, so this is just a though experiment for later in
the
> > spring.
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>



<Prev in Thread] Current Thread [Next in Thread>