What a question! Most of their rigs require you to remove all knobs, control
nuts, front panel, freq. counter then finally the pto. You first one is
quite a challenge. Really, all you needed was to clean the old grease out
and use some silicon in it's place. White silicon grease works better than
that sticky red stuff they give you. Have fun!
Steve
N4LQ
If two wrongs don't make a right, try three.
----- Original Message -----
From: "Kevin L Anderson" <k9iua@juno.com>
To: <tentec@contesting.com>
Sent: Saturday, March 16, 2002 5:08 PM
Subject: [TenTec] Argosy PTO rebuild -- how to disassemble?
> I have an Argosy II that desparately needs its
> PTO rebuilt. I have the necessary PTO rebuild
> kit from Ten-Tec for the task.
>
> However, how do I begin? How do I get at the
> PTO to the point where I begin the directions
> in the rebuild kit? What all do I need to do --
> remove the front panel? Remove the PTO
> container box? Help...
>
> Can someone please give me the additional
> step-by-step instructions I need to proceed?
> I haven't done something like this before, and
> I hesitate to even attempt it, lest I mess something
> up. The other option is for me to see if the home
> factory could do this job for me at whatever the cost.
>
> Thanks in advance.
>
> Cheers/73. Kevin, K9IUA
> * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
> Kevin Anderson, K9IUA, Dubuque, Iowa
> e-mail: K9IUA@juno.com Opinions all my own.
> * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
>
>
> ________________________________________________________________
> GET INTERNET ACCESS FROM JUNO!
> Juno offers FREE or PREMIUM Internet access for less!
> Join Juno today! For your FREE software, visit:
> http://dl.www.juno.com/get/web/.
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
|