The only computer control for the Jupiter is in Pegasus emulation mode.
Carl Moreschi N4PY
Franklinton, North Carolina
n4py@earthlink.net
----- Original Message -----
From: "Carl J. Denbow" <ka8jxg@callsign.net>
To: <tentec@contesting.com>
Sent: Friday, May 11, 2001 10:16 PM
Subject: Re: [TenTec] Jupiter Computer Control in non-Pegasus Mode
>
> So far I've received two "off-list" responses to this query. One
> said it was possible but gave no details. The other said that in
> non-Pegasus mode the serial port could only be used for firmware
> updates. Would anyone like to go "on-the-record" with a response and
>
> enough details to know what codes are used, if this is possible?
> I've heard that the OMNI rigs use ICOM-compatible codes? Is this
> what the Jupiter would use in non-Pegasus mode? Thanks for any
> further clarification anyone can give.
>
> 73
>
> Carl
>
> On Thu, 10 May 2001 23:34:26 -0400, wrote:
> >Does anyone know if the Jupiter can be computer controlled when it
> >in non-Pegasus mode? That is, will it recognize any commands coming
> >through the serial port. This would certainly be a nice feature.
> I've
> >found that I often like to use the rig with the knobs rather than
> the
> >software. At the same time I'd like to have my logging program be
> >able to "speak" to the Jupiter and also "hear" its frequency
> >information. Anyone know about this? Thanks.
> >
> >Carl
> >
>
> ================================
> Carl J. Denbow
> KA8JXG
> 17 Coventry Lane
> Athens, Ohio USA
>
> EM89
> Working on WAS and DXCC
> ================================
> Message sent from ka8jxg@callsign.net on 05/11/2001
>
>
> --
> FAQ on WWW: http://www.contesting.com/FAQ/tentec
> Submissions: tentec@contesting.com
> Administrative requests: tentec-REQUEST@contesting.com
> Problems: owner-tentec@contesting.com
>
--
FAQ on WWW: http://www.contesting.com/FAQ/tentec
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
|