So far I've received two "off-list" responses to this query. One
said it was possible but gave no details. The other said that in
non-Pegasus mode the serial port could only be used for firmware
updates. Would anyone like to go "on-the-record" with a response and
enough details to know what codes are used, if this is possible?
I've heard that the OMNI rigs use ICOM-compatible codes? Is this
what the Jupiter would use in non-Pegasus mode? Thanks for any
further clarification anyone can give.
73
Carl
On Thu, 10 May 2001 23:34:26 -0400, wrote:
>Does anyone know if the Jupiter can be computer controlled when it
>in non-Pegasus mode? That is, will it recognize any commands coming
>through the serial port. This would certainly be a nice feature.
I've
>found that I often like to use the rig with the knobs rather than
the
>software. At the same time I'd like to have my logging program be
>able to "speak" to the Jupiter and also "hear" its frequency
>information. Anyone know about this? Thanks.
>
>Carl
>
================================
Carl J. Denbow
KA8JXG
17 Coventry Lane
Athens, Ohio USA
EM89
Working on WAS and DXCC
================================
Message sent from ka8jxg@callsign.net on 05/11/2001
--
FAQ on WWW: http://www.contesting.com/FAQ/tentec
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
|