Bill:
I'm using the following settings: baud rate 19200, databits 8, parity none,
stop bits one, rx addr 1, rs232 nonmultidrop.
Be sure to update the Pegasus.ini file per Carl's notes.
Good Luck!
73 de Greg, K7KJ
Portland, OR
>
> I decided to trade in the 331 receiver for the 340. there were
> several reasons and none had to do with performance. however, I can
> no longer communicate to the 340 with my software and cable. anyone
> doing this and can give me the S1.S2 settings. the only change was
> that I set the S2 for no multidrop and reset the baud rate to 19.2
> per carl's suggestions. The higher baud rate does not work either.
> Any suggestions??
> Bill Taylor
>
> --
> FAQ on WWW: http://www.contesting.com/FAQ/tentec
> Submissions: tentec@contesting.com
> Administrative requests: tentec-REQUEST@contesting.com
> Problems: owner-tentec@contesting.com
>
>
--
FAQ on WWW: http://www.contesting.com/FAQ/tentec
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
|