I decided to trade in the 331 receiver for the 340. there were
several reasons and none had to do with performance. however, I can
no longer communicate to the 340 with my software and cable. anyone
doing this and can give me the S1.S2 settings. the only change was
that I set the S2 for no multidrop and reset the baud rate to 19.2
per carl's suggestions. The higher baud rate does not work either.
Any suggestions??
Bill Taylor
--
FAQ on WWW: http://www.contesting.com/FAQ/tentec
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
|