Maybe your Triton II runs at 12 volts. My OMNI 6+ runs at 13.5
volts in receive mode, measured at the auxiliary power jack on the
back of the OMNI. I'm using the Ten-Tec 9420 power supply (the big
one that also powers the Herc II). Under full load it drops to
12.5 volts but most of the time we are just listening - right? I
have had no problem with panel lamps.
---
73, Rich - W3ZJ
> -----Original Message-----
> From: owner-tentec@contesting.com
> [mailto:owner-tentec@contesting.com]On
> Behalf Of Frank Krozel
> Sent: Thursday, September 14, 2000 12:34 PM
> To: tentec@contesting.com
> Subject: [TenTec] Ten Tec rigs and "other" power supplies
>
>
>
> I love to trade rigs, and from time to time I get a Ten
> Tec rig with burned
> out bulbs. In addition, I see people using a Ten Tec
> rig with "another"
> power supply.
> As the Ten Tecs all run at 12 volts, as opposed to 13.8
> or higher volts, I
> am curious IF there is a connection with burned out
> bulbs ( are Ten Tec's
> rated at 12 volts? ) and using "other" supplies.
> My Ten Tec Triton II (yes 2!) still has the original
> bulbs in it, but the
> supply is the matching one, set at 12 volts or so.
> Frank Krozel
> KG9H
>
>
>
> --
> FAQ on WWW: http://www.contesting.com/FAQ/tentec
> Submissions: tentec@contesting.com
> Administrative requests: tentec-REQUEST@contesting.com
> Problems: owner-tentec@contesting.com
>
--
FAQ on WWW: http://www.contesting.com/FAQ/tentec
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
|