On the Omni V DC power connector there are 4 pins:. +12 and GND go on the
outside two. On the power cable that came with my rig, the center two were
jumpered together. Everything works fine when I connect the power cable to
my Astron 12V supply, but I wonder what the center two pins are for? I
suspect that they turn a Ten-Tec power supply on and off in respone to the
Omni V's power switch, but the schematic just shows them jumpered. Could I
use these to control On/Off on my Astron supply?
73,
Mark, N8ME
--
FAQ on WWW: http://www.contesting.com/FAQ/tentec
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
|