--- Original Message ---
"Frank Krozel" <frank@electronicinstrument.com> Wrote on
Thu, 14 Sep 2000 11:34:14 -0500
------------------
As the Ten Tecs all run at 12 volts, as opposed to
13.8 or higher volts, I am curious IF there is a
connection with burned out bulbs ( are Ten Tec's
rated at 12 volts? ) and using "other" supplies.
------------------
I'm not sure where the idea of TenTecs running at 12v comes from,
but this is from their web page concerning the power supply for
the Omni series -
"Model 962, Power Supply/Speaker - Cosmetically matches OMNI-VI
PLUS, 115/230 VAC, 50/60 Hz input. 13.8 VDC, 22 A output. Resetting
electronic latching circuit breaker limits current to protect
transceiver. "
Mine puts out 13.8 too, not 12
Frank
W2FCA
--
FAQ on WWW: http://www.contesting.com/FAQ/tentec
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
-----
Sent using MailStart.com ( http://MailStart.Com/welcome.html )
The FREE way to access your mailbox via any web browser, anywhere!
--
FAQ on WWW: http://www.contesting.com/FAQ/tentec
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
|