Les,
I had a similar problem. I had a potentiometer with
with one leg grounded and the wiper to line in. I
found that I had to put a resistor in series with the
line connection, I think it was 100k. Seems loading
the line-in causes some stray signals.
--- Les Warriner <leswa7ham@bentonrea.com> wrote:
> OK Gurus, I got a propblem. Got the Pegasus
> harnessed up to a Yamaha
> Sound Card. Have 1:1 isolation transformers in both
> audio in and audio out
> on the Pegasus. Have a 100:1 pad in the audio in
> cable. Have juggled RF
> power output, microphone in, etc., no change.
> Problem: ALC never goes out!! Reports are that my
> signal is wide.
> Incidentally, my sound card has both line in/out and
> speaker out and am
> using line in/out. Also am using the accessory in on
> the Pegasus, not the
> microphone in.
> Anybody got any experience in this Transceiver or
> this problem. TenTec
> can only say put in a pad which was already in. Then
> they talk ground loop
> even tho both lines are isolated. I'd sure like to
> operate PSK but not
> without an acceptable signal.
> Thanks Guys!!! 73
>
>
------------------------------------------------------------------------
> Unique Valentine gifts, available now at eGroups.
>
http://click.egroups.com/1/1154/1/_/3545/_/949679410/
>
>
> eGroups.com home:
> http://www.egroups.com/group/logger
> http://www.egroups.com - Simplifying group
> communications
>
>
>
>
>
=====
NT4ZO
__________________________________________________
Do You Yahoo!?
Talk to your friends online with Yahoo! Messenger.
http://im.yahoo.com
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|