Clean and lubricate the bandswitch with the stuff Ten-Tec uses or for about
the same money as buying those two cans of stuff, send the rig to them and
let them go over it.
73 de Mike N4NT@wireco.net
----- Original Message -----
From: <ARDUJENSKI@aol.com>
To: <TenTec@contesting.com>
Sent: Sunday, December 26, 1999 12:48 PM
Subject: [TenTec] BANDSWITCH PROBLEM
>
> On my OMNI-D the band selector switch will cause a bit of a problem by not
> making good contact and get then get an intermittant 9.000 on the readout.
Is
> there a simple fix short of replacing the bandswitch? Alan KB7MBI
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|