TenTec
[Top] [All Lists]

[TenTec] 509 front panel disassembly

To: <tentec@contesting.com>
Subject: [TenTec] 509 front panel disassembly
From: aluscre@neo.rr.com (aluscre)
Date: Wed, 24 Nov 1999 18:39:54 -0500
Don the only tricky part is the main tuning knob which requires the correct
width flat blade screww drive or a small improvised tool. I could scan and
foward the pages to you if you would like.

Don Tuite wrote:

> I just discovered that the manual for my Argonaut 509 is missing pages 3-2
> and 3-3, which apparently describe front panel disassembly and dial-cord
> replacement/recallibration.
>
> It this particular process non-intuitive in any way?  Can I just take the
> knobs off, unscrew the four screws on the bottom side of the faceplate and
> proceed?
>
> Don
> NR7X
> _______________________________________
> Don Tuite  Technical Writing Supervisor
> KVO                    Public Relations
> 650/919-2030 v        don_tuite@kvo.com
> 650/919-9976 f       http://www.kvo.com
> _______________________________________
>
> --
> FAQ on WWW:               http://www.contesting.com/tentecfaq.htm
> Submissions:              tentec@contesting.com
> Administrative requests:  tentec-REQUEST@contesting.com
> Problems:                 owner-tentec@contesting.com
> Search:                   http://www.contesting.com/km9p/search.htm

--
|--------------------------|
| Anthony A. Luscre    |
|  KA8NRC         |
|        Stow, Ohio    |
|--------------------------|



--
FAQ on WWW:               http://www.contesting.com/tentecfaq.htm
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 owner-tentec@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm


<Prev in Thread] Current Thread [Next in Thread>