TenTec
[Top] [All Lists]

[TenTec] 509 front panel disassembly

To: <tentec@contesting.com>
Subject: [TenTec] 509 front panel disassembly
From: don_tuite@kvo.com (Don Tuite)
Date: Tue, 23 Nov 1999 13:54:41 -0800
I just discovered that the manual for my Argonaut 509 is missing pages 3-2
and 3-3, which apparently describe front panel disassembly and dial-cord
replacement/recallibration.

It this particular process non-intuitive in any way?  Can I just take the
knobs off, unscrew the four screws on the bottom side of the faceplate and
proceed?

Don
NR7X
_______________________________________
Don Tuite  Technical Writing Supervisor
KVO                    Public Relations
650/919-2030 v        don_tuite@kvo.com
650/919-9976 f       http://www.kvo.com
_______________________________________

--
FAQ on WWW:               http://www.contesting.com/tentecfaq.htm
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 owner-tentec@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm


<Prev in Thread] Current Thread [Next in Thread>