On Mon, Nov 03, 2003 at 09:34:16AM +0000, Dave Hachadorian wrote:
> Let's see if I can describe this properly.
>
> v6.78, so2r, with the bandmap for the run radio
> band displayed. Lots of Telnet spots in the
> bandmap.
>
> I do a ctrl-end to get the cursor in the bandmap,
> highlight a desired station, press enter, and the
> s&p radio goes to the desired station. The station
> appears in the alt-d on-deck circle. ok so far.
>
> I press the spacebar, work the station, and,
> after all the dust settles, I am back on the
> run radio ready to work callers there. However,
> NOW THE BANDMAP FOR THE RUN RADIO IS DISPLAYED.
> It stays there until I twiddle the knob of the
> s&p radio. I think it would be much more logical
> to keep the s&p band displayed. A couple of times
> I forgot and sent my CQ RADIO off to a different
> frequency, losing my run freq! To get the bandmap
> on the s&p band, I deliberately had to reach over
> and twiddle the knob.
>
> Is this a program problem, or are there some config
> settings or keystrokes that I am missing?
I think there might be a rough edge there. I also noticed that
your CQ back on the run radio ends up on the bandmap on the frequency
of your Alt-D QSO - which was fixed by removing CQs from the bandmap.
I took a few other notes as well - was my first real contest with
one of the newer versions.
However, the program worked okay for me - I did have one strange thing
where I ended up in the exchange window and the keystrokes were not
doing anything.
Tree
_______________________________________________
Trlog mailing list
Trlog@contesting.com
http://lists.contesting.com/mailman/listinfo/trlog
|