Let's see if I can describe this properly.
v6.78, so2r, with the bandmap for the run radio
band displayed. Lots of Telnet spots in the
bandmap.
I do a ctrl-end to get the cursor in the bandmap,
highlight a desired station, press enter, and the
s&p radio goes to the desired station. The station
appears in the alt-d on-deck circle. ok so far.
I press the spacebar, work the station, and,
after all the dust settles, I am back on the
run radio ready to work callers there. However,
NOW THE BANDMAP FOR THE RUN RADIO IS DISPLAYED.
It stays there until I twiddle the knob of the
s&p radio. I think it would be much more logical
to keep the s&p band displayed. A couple of times
I forgot and sent my CQ RADIO off to a different
frequency, losing my run freq! To get the bandmap
on the s&p band, I deliberately had to reach over
and twiddle the knob.
Is this a program problem, or are there some config
settings or keystrokes that I am missing?
Dave Hachadorian, K6LL
Yuma, AZ
_______________________________________________
Trlog mailing list
Trlog@contesting.com
http://lists.contesting.com/mailman/listinfo/trlog
|