Hi Tony,
I use 751A with UX14 for many years. Set Baud rate to 1200, Transceive off,
check that address is set for 28 (1C). Try is with version before 6.70 first
(defaults in earlier versions work OK). Should work.
There are 3 more 751A around and they all work with these settings.
73, Igor UA9CDC
> I just bought a Piexx board to use Tr with my 751A (the silence was
> deafening BTW on my last post). Would someone please tell me if this will
> ever work, or do I need to forget it and eat the Piexx board.
>
> I tried looking in the manual, I searched Google...nothing. I looked at
the
> README notes. I tried 6.72 and 6.73. I changed the baud rate to 4800. I
> tried every combo of IC735, IC765, IC761, etc and nothing is working. Yes,
I
> even tried COM1 and COM2...Transceiver mode, 1 stop bit, 2 stop bits, etc.
>
> IC751 and IC751A report errors...ok., if its not supported anymore why
isn't
> that mentioned somewhere (before I spent the money).
>
> Am I hot? Yes. I like TR, but I am not a person who can just buy a new
Orion
> or MP so I have to make due with older rigs.
>
> Suggestions? Help!? Piexx was two days to my door and very good on the
> phone.
>
> Here is the config file (one of many):
> RADIO ONE TYPE = IC761
> RADIO ONE RECEIVER ADDRESS = 28
> RADIO ONE CONTROL PORT = SERIAL 2
>
> Thanks!
> Tony (maybe up too late to be working on this anyway)
>
>
> _______________________________________________
> Trlog mailing list
> Trlog@contesting.com
> http://lists.contesting.com/mailman/listinfo/trlog
_______________________________________________
Trlog mailing list
Trlog@contesting.com
http://lists.contesting.com/mailman/listinfo/trlog
|