Did you hit Alt-Q before?
It has always worked OK with me, no doubt.
The only strange thing I noticed is
if you have some Ctrl characters to increase
the speed and the correspondent ones to reduce
to the initial value
(for instance to send TEST faster)
and if you let the CQ go, run after run
the CW speed is slightly increased
and after a couple of minute,
if you had an initial speed say 32
your transmit speed becomes higher
abt 40/42 and continuosly increasing.
If you hit ESC to stop and then Alt-C
again the CQ start with the last reached speed.
If you hit F1 this reset the speed value
to the initial one and the next Alt-C
will start from 32 (and still will
increase at each run).
Anybody notice this before??
Bob,I2WIJ - J49WI
mailto:i2wij@qsl.net
http://www.qsl.net/i2wij/
-----Original Message-----
From: K5NZ@aol.com [mailto:K5NZ@aol.com]
Sent: Saturday, August 14, 1999 2:29 PM
To: trlog@contesting.com
Subject: [TRLog] Alt C
Ver. 6.42
Anyone else see that Alt C (auto cq resume) is not working?
mike k5nz
--
FAQ on WWW: http://www.contesting.com/trlogfaq.html
Submissions: trlog@contesting.com
Administrative requests: trlog-REQUEST@contesting.com
Problems: owner-trlog@contesting.com
Feature Wishlist: http://web.jzap.com/n6tr/trwish.html
--
FAQ on WWW: http://www.contesting.com/trlogfaq.html
Submissions: trlog@contesting.com
Administrative requests: trlog-REQUEST@contesting.com
Problems: owner-trlog@contesting.com
Feature Wishlist: http://web.jzap.com/n6tr/trwish.html
|