> (1) About 33% of the time, when using AUTO CQ, the next CQ sequence
> starts immediately after the last one, ignoring the 6 second delay I
> have set...???
SSB or CW?
> (2) Somewhat related during the AUTO CQ process is that the information
> window (below EXCHANGE WINDOW that shows "..pgup/pgdn to change
> delay...etc") will disappear, maybe change to show somekind of freq
> display, then gooble-gook, maybe show half the sentence, then settle
> down....??
Sounds like you have a radio interfaced? Perhaps I left some kind of
debug message in there?
> (3) During AUTO CQ: sometimes the mode will flip-flop back and forth
> between 20M CW and 20M NonSSB and so on........the freq display might
> then show most any kind of number.....??
Sounds like the radio and computer aren't talking very well. What
kind of radio do you have interfaced?
> (4) Entering a call with a known NAME may or may not display the NAME or
> QTH when using CQ EXCH NAME.....In testing, if you enter the same call
> two times in a row (ie, simulate a QSO, then delete it with Alt Y , then
> re-enter the same call..etc) it will not find the name the first time
> but will always find the name the 2nd time...???
There are some places where I don't display the name if it is the same
callsign as the last time I put up a name. Perhaps there are a few
of these where the name got erased. This shouldn't be a problem during
normal operation.
> Could be that 1 thru 3 above is just RF interference between
> radio(IC765) and/or PC and/or the radio-to-PC interface?.....Or it is
> all related to communications difficulties between 765 and TR Log??
Ahha! The IC765 and TR aren't talking to each other very well. N7TR
is sending me one and I hope to have some improvements soon.
Tree
--
FAQ on WWW: http://www.contesting.com/trlogfaq.html
Submissions: trlog@contesting.com
Administrative requests: trlog-REQUEST@contesting.com
Problems: owner-trlog@contesting.com
Feature Wishlist: http://web.jzap.com/n6tr/trwish.html
|