Date: Fri, 22 May 1998 13:32:19 -0500
From: Ron Chambers <rchambers@mycon.com>
To: trlog@contesting.com
Subject: Auto CQ Loop
Looking for comments/suggestions/help related to the following:
(1) About 33% of the time, when using AUTO CQ, the next CQ sequence
starts immediately after the last one, ignoring the 6 second delay I
have set...???
(2) Somewhat related during the AUTO CQ process is that the information
window (below EXCHANGE WINDOW that shows "..pgup/pgdn to change
delay...etc") will disappear, maybe change to show somekind of freq
display, then gooble-gook, maybe show half the sentence, then settle
down....??
(3) During AUTO CQ: sometimes the mode will flip-flop back and forth
between 20M CW and 20M NonSSB and so on........the freq display might
then show most any kind of number.....??
(4) Entering a call with a known NAME may or may not display the NAME or
QTH when using CQ EXCH NAME.....In testing, if you enter the same call
two times in a row (ie, simulate a QSO, then delete it with Alt Y , then
re-enter the same call..etc) it will not find the name the first time
but will always find the name the 2nd time...???
-----
Could be that 1 thru 3 above is just RF interference between
radio(IC765) and/or PC and/or the radio-to-PC interface?.....Or it is
all related to communications difficulties between 765 and TR Log??
----
73
Ron
please, direct replies to K5PN@msn.com
--
FAQ on WWW: http://www.contesting.com/trlogfaq.html
Submissions: trlog@contesting.com
Administrative requests: trlog-REQUEST@contesting.com
Problems: owner-trlog@contesting.com
Feature Wishlist: http://web.jzap.com/n6tr/trwish.html
|