WINKEY is OFF
SHARECOM is ON
When I run through the PORTS process I get confirmation that port sharing is
working for COM 3.
However - I see no freq display nor do I have CW keying. There is no error
message.
Have tried SD ICOM files for IC718 IC7700 IC7800.
Tried to open IC7700 SD control file but don't know how to do it in order to
change the control address.
How do I edit the IC7700 (or any ICOM ) cointrol file?
73 Frank VO1HP
----- Original Message -----
From: "RFD" <fdavis@nfld.net>
> Will SDI support the IC-7200?. It uses a USB interface
> to the PC with driver software.
That's a good question, sorry I don't know the answer.
Is anyone already using rig control with the IC7600?
> When I tried to bring up COM 3 in SDI it doesn't "see"
> the port.
What error message did SDI display? I presume you're
using another of SD's Icom control files with the
control address on Line 2 changed to 118 (76 Hex)?
73,
Paul EI5DI
_______________________________________________
SD-User mailing list
SD-User@contesting.com
http://lists.contesting.com/mailman/listinfo/sd-user
|