----- Original Message -----
From: "RFD" <fdavis@nfld.net>
> Will SDI support the IC-7200?. It uses a USB interface
> to the PC with driver software.
That's a good question, sorry I don't know the answer.
Is anyone already using rig control with the IC7600?
> When I tried to bring up COM 3 in SDI it doesn't "see"
> the port.
What error message did SDI display? I presume you're
using another of SD's Icom control files with the
control address on Line 2 changed to 118 (76 Hex)?
73,
Paul EI5DI
_______________________________________________
SD-User mailing list
SD-User@contesting.com
http://lists.contesting.com/mailman/listinfo/sd-user
|