N2ICs WB is up and running fine with the SDRplay already. What do I need to set
up in N1MM+?
John GW4SKA
-----Original Message-----
From: k8ut@k8ut.com [mailto:k8ut@k8ut.com]
Sent: 27 October 2017 17:53
To: John Barber <john@bordertech.co.uk>; rtty@contesting.com
Subject: Re: [RTTY] N1MM+ and Waterfall Bandmap
John,
The current version of N1MM+'s Spectrum Display requires an input signal from
an Icom CAT array of data points. It was designed for the new Icom radio's
built-in spectrum processor. Your SDRplay outputs an incompatible IF/IQ signal.
N2IC's Waterfall Bandmap program - itself a valuable tool for N1MM contesters -
includes the IF/IQ -to- CAT translator required by Spectrum Display to allow
non-new-Icom radios to use the Spectrum Display. You have to first get WB
running before trying to get SD to work.
-larry (K8UT)
------ Original Message ------
From: "John Barber" <john@bordertech.co.uk>
To: rtty@contesting.com
Sent: 2017-10-27 12:29:38
Subject: [RTTY] N1MM+ and Waterfall Bandmap
>Maybe someone here can answer a question about N1MM and the spectrum
>display. I know there is a N1MM group but I have never used it so am
>trying here first!
>
>I have Waterfall Bandmap set up with an SDRPlay RSP1 and it works fine.
>My
>problem is that the N1MM Spectrum Window doesn't see the RSP1 as an
>option when selecting the spectrum source. The N1MM help file says to
>open N1MM first, then Waterfall Bandmap, then open the spectrum window.
>
>How do I get the RSP1 to send an ident to N1MM, or otherwise get them
>connected?
>
>John GW4SKA
>
>
>
>
>
>---
>This email has been checked for viruses by AVG.
>http://www.avg.com
>_______________________________________________
>RTTY mailing list
>RTTY@contesting.com
>http://lists.contesting.com/mailman/listinfo/rtty
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
|