RTTY
[Top] [All Lists]

Re: [RTTY] Intel NUC, anyone?

To: <rtty@contesting.com>
Subject: Re: [RTTY] Intel NUC, anyone?
From: "David G3YYD" <g3yyd@btinternet.com>
Date: Fri, 27 Oct 2017 18:00:59 -0000
List-post: <mailto:rtty@contesting.com>
Jim

Yes to 2Tone. It is really simple to set up.

73 David G3YYD

-----Original Message-----
From: RTTY [mailto:rtty-bounces@contesting.com] On Behalf Of Jim N7US
Sent: 27 October 2017 17:08
To: 'Joe Subich, W4TV'; rtty@contesting.com
Subject: Re: [RTTY] Intel NUC, anyone?

Is the FSK produced by MMTTY or 2Tone and an Edgeport 45.45 baud?

73, Jim N7US

-----Original Message-----



Edgeport is the only maker of USB to Serial converters that I know of that
properly support low (45, 50 and 75 baud) data rates.  Again, their
converters are microprocessor based with a hardware bit clock.  It is not
necessary to use EXTFSK or other software FSK "drivers" with the Edgeport
products.

73,

    ... Joe, W4TV


On 10/27/2017 10:42 AM, Jim McDonald wrote:
> Would an Edgeport USB-to-serial adaptor work?
> 
> 73,  Jim N7US
> 
> -----Original Message-----
> 
> Hi Peter,
> 
> Have you looked into TinyFSK?
> 
> http://www.frontiernet.net/~aflowers/tinyfsk/
> 
> I was looking into doing something similar as you with either a small 
> form factor PC, cheap laptop or some other device (which I still have 
> to
get).
> Realizing that they would not have a serial port for FSK keying, I 
> built an interface that included the TinyFSK. It worked very well for 
> me. I used it with the N1MM logging software for some contesting as well.
> 
> 73,
> --Alex KR1ST
> 
> 
> On 2017-10-25 22:31, Peter Laws wrote:
> 
>> Now my problem is that the NUC has no serial ports.

_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty

_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty

<Prev in Thread] Current Thread [Next in Thread>