Don,
I am using two SI-PEX50054 cards (2S1P each). Windows 8.1 had built in drivers
when I installed them.
They still work after upgrading to Windows 10. I would expect you should have a
similar experience with the PEX15011 card.
The only issue I had was Win 10 did a fruit basket turnover by assigning
different Comm numbers to the serial ports.
The Parallel ports remained the same.
73, Jim – w5ifp@gvtc.com
>> -----Original Message-----
>> From: RTTY [mailto:rtty-bounces@contesting.com] On Behalf Of Don
>> AA5AU
>> Sent: Friday, July 31, 2015 5:04 PM
>> To: RTTY Reflector <rtty@contesting.com>
>> Subject: [RTTY] Syba SD-PEX15011 & Windows 10
>>
>> Since this directly affects my abilitly to operate FSK, hopefully
>> this is OK for this forum.
>> When I bought my Windows 8.1 desktop PC, I installed a 4-port PCI-
>> Express card (Syba SD-PEX15011). This gave me four legacy serial
>> ports to be used for radio control, FSK, rotor control, etc. I then
>> relayed my success with this combination (Windows 8.1 + SD-
>> PEX15011) to this reflector. Now I'm wondering if anyone who has a
>> SD-PEX15011 card installed has upgraded to Windows 10 and if the card
>> still works.
>> If I don't hear from anyone, I may just have to just upgrade and hope
>> for the best. I would really like to upgrade the shack PC from
>> 8.1 to 10.
>>
>> Thanks,Don AA5AU
>> _______________________________________________
>> RTTY mailing list
>> RTTY@contesting.com
>> http://lists.contesting.com/mailman/listinfo/rtty
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
|