RTTY
[Top] [All Lists]

Re: [RTTY] Looking for an interface - a few simple requirements

To: rtty@contesting.com
Subject: Re: [RTTY] Looking for an interface - a few simple requirements
From: Jay WS7I <ws7ik7tj@gmail.com>
Reply-to: ws7ik7tj@gmail.com
Date: Wed, 02 Oct 2013 08:26:50 -0700
List-post: <rtty@contesting.com">mailto:rtty@contesting.com>
That's not quite right, Chen. Slow RTTY has been around for quite a while. Comes from improperly set up software programs most of which were around a lot longer than K3's and there weird paddle. Not the Microham stuff either.

In fact I had it once using MMTTY at a place where I contest on occasion. This was an old MMTTY setup on a Win98 box. Solved that my updating Writelog, the computer to something newer and a newer version of MMTTY.



On 10/1/2013 5:38 PM, Kok Chen wrote:
I had earlier written to Peter that although the MicroHam interfaces cannot achieve precise 45.45 
baud transmission, that the hardware cannot be the cause of any of the "slow RTTY" that 
we hear -- simply because I have never heard "slow RTTY" come from my uH Router program.  
If it were a hardware problem, I will have problems too.

I would challenge any "golden ears" to tell the difference between 45.45 baud 
and 45.0 baud (and you can actually get closer to 45.45 than 45.0 with a MicroKeyer if 
you program the division ratio correctly -- presumably all software is doing that 
already).  Heck, the majority of RTTY ops cannot tell the difference between 1 stop bit 
and 2 stop bits and the character rate difference is much larger there.  Due to because 
of the extra keying sidebands it is actually easier to tell 1.5 stop bit from 1 stop bit.

The most likely cause of the "slow RTTY" are Elecraft K3, running in FSK-D and 
keyed by using a Morse paddle (yes, the Amateur community spans a range of intelligence 
:-).

MicroKeyers have been in existence for a long time and no one noticed "slow 
RTTY" until Elecraft implemented FSK-D wrongly (by not immediately issuing a diddle 
while the op is in the middle of paddling in a long Morse character like a zero or a 9).

73
Chen, W7AY


_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty

<Prev in Thread] Current Thread [Next in Thread>