The K3 switches to the last used digital mode each time
you change modes. Go band to band and change mode to AFSK A
on each band. Also check to see what mode commands your
logging/digital software might be sending.
73,
... Joe, W4TV
On 9/28/2013 7:26 AM, paul ecker wrote:
Joe- found that for some reason- the K3 keeps switching out of AFSK-A, to other
digital modes-when I switch it back- all Ok for a while and then it switches
again- seems sometimes it happens after changing. Any idea why that would
happen?
________________________________
From: "Joe Subich, W4TV" <lists@subich.com>
To: rtty@contesting.com
Cc: paul ecker <eckerpw@yahoo.com>
Sent: Friday, September 27, 2013 9:58 PM
Subject: Re: [RTTY] Need Help
Make sure K3 DATA mode is AFSK A not FSK D. Signalink is a dumb USB
sound card, not an FSK interface.
73,
... Joe, W4TV
On 9/27/2013 9:22 PM, paul ecker wrote:
I thought I had all setup for contest this weekend. Had both N1MM set and MMTTY
as a backup ready. But tonight when I tried to jump in found that when I try to
Tx, I get a solid tone, no diddles. Any obvious things to check that might
cause this? Have a K3 and signalink USB interface.
thanks
Paul
kc2nyu
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
|